Table of Contents
Advertisement
Quick Links
Before using your 2PC / 2PCKA, read this manual carefully and
APPLICATION, EXPORT, AND RECONSTRUCTION
1. Use this product in models only.
The product described in this manual is subject to regulations of the Ministry of Ra-
dio/Telecommunications and is restricted under Japanese law to such purposes.
2. Exportation precautions
(a) When this product is exported from Japan, its use is to be approved by the Radio
Law of the country of destination.
(b) Use of this product with other than models may be restricted by Export and Trade
Control Regulations. An application for export approval must be submitted.
3. Modification, adjustment, and replacement of parts
Futaba is not responsible for unauthorized modification, adjustment, and replace-
ment of parts of this product.
THE FOLLOWING STATEMENT APPLIES TO THE RECEIVER (FOR U.S.A.)
This device complies with part 15 of the FCC rules. Operation is subject to the fol-
lowing two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
-No part of this manual may be reproduced in any form without prior permission.
-The contents of this manual are subject to change without prior notice.
-This manual has been carefully written. Please write to Futaba if you feel that any corrections or clarifications
should be made.
-Futaba is not responsible for the use of this product.
-Futaba is registered trademarks of FUTABA Corporation.
Thank you for purchasing a Futaba 2PC / 2PCKA.
use your R/C set safely.
After reading this manual, store it in a safe place.
Advertisement
Table of Contents
Related Manuals for FUTABA 2PC
Summary of Contents for FUTABA 2PC
- Page 1 -No part of this manual may be reproduced in any form without prior permission. -The contents of this manual are subject to change without prior notice. -This manual has been carefully written. Please write to Futaba if you feel that any corrections or clarifications should be made.
-
Page 2: Table Of Contents
Table Of Contens 2PC / 2PCKA Safety Precautions ..............2 Definition Of Symbols ....................... 2 Running Preparations Safety Precautions ..............2 Running Safety Precautions ..................... 3 Storage And Disposal Safety Precautions ..............4 Other Safety Precautions ....................5 Before Operation ............... 6 System Contents ........................ -
Page 3: Safety Precautions
Safety Precautions 2PC / 2PCKA For your safety as well as that of others. Please read this manual thoroughly prior to instal- lation and operation of your digital proportional R/C system. Definition Of Symbols The following defines the symbols used in this manual. -
Page 4: Running Safety Precautions
Running (Sailing) Safety Precautions Warning Conduct Tests Prior to operation always preform a range test. Even one abnormality in the R/C system may cause loss of control. [Range Test Procedure] Have a friend hold the model, or place on a stand where the wheels or prop can not come in contact with any object. -
Page 5: Storage And Disposal Safety Precautions
Prohibited Do not operate when you are tired, not feeling well or under the influence of alcohol or drugs. Your judgement is impaired and could result in a dangerous situation that may cause serious injury to yourself and others. Before you turn on the power switch on the transmitter, always check to see that the trigger is at the neutral position. -
Page 6: Other Safety Precautions
Always use only genuine Futaba receiver, servos, electronic speed controls along with other optional parts and components. Futaba will not be held responsible for damages caused by other than genuine Futaba parts and components. Use only genuine Futaba parts and components listed in the instruction manual and catalog. -
Page 7: Before Operation
Before Operation 2PC / 2PCKA System Contents After opening the container, check the contents for the following items. the contents will vary with the system purchased. System with System with System with 1 MC210CB and 1 MC310CB and 2 Servos... -
Page 8: Nomenclature / Handling
Nomenclature / Handling Transmitter T2PC / T2PCKA Power Switch Antenna *When slid upward, the power is turned on. Servo Reversing Switch (P14) Steering ATV (P14) (only T2PCKA) Steering Wheel *Turn model to left or right. Battery Level Indicator Steering Trim (P13) *Three LED display to indicate DIGITAL PROPORTIONAL T2PCKA... -
Page 9: Battery Replacement
Battery Replacement Caution Battery cover Always be sure you reinsert the batteries in the correct polarity order. Open If the batteries are loaded incorrectly , the transmitter may be damaged. When the transmitter will not be used for any short or long period of time always remove the batteries. -
Page 10: Assembly / Adjustment
Assembly / Adjustment 2PC / 2PCKA Receiver And Servo Connection As you connect the receiver, servo's and other components, do so in accordance with the "Assembly Precautions" listed on the next page. Connections when a E.S.C. MC210CB or MC310CB are used. -
Page 11: Assembly Precautions
Use only genuine Futaba crystal set's as specified in this instruction manual. The use of other than Futaba crystal set's will result in decrease of range as well as loss of control. There are separate crystal's for the Transmitter and Receiver, there are also crystal set's for AM, FM and Dual Conversion FM. - Page 12 Caution Disassembly Prohibited Do Not disassemble any part of this system that is not specified in the instruction manual. Futaba will not be responsible for any damage due to improper disassembly of any part of the radio control system.
-
Page 13: Digital Proportional Adjustment
Digital Proportional Adjustment *When making these settings adjustments , do so with the motor disconnected or the engine not running. Servo Horn Installation Instructions. Connect the receiver, servos, and other components and then turn on the power switches to transmitter and receiver. Be sure the Steering trim and Throttle trim on the transmitter Both servos will move to the neutral position. -
Page 14: Description Of Functions
Description Of Functions 2PC / 2PCKA Steering Trim Steering neutral adjustments can be made by moving the Steer- Steering Trim ing trim knob to the left or right. Racers Tip ST.TRIM When you install a servo always check to be sure the servo TH.TRIM... -
Page 15: Servo Reverse
Servo Reverse This function reverses the rotation direction of the Steering and Steering Throttle servos. N Side: Normal R Side: Reverse SERVO When the trim position deviates from the center, the de- REV SW Throttle viation will be on the opposite side when the servo is N Side: Normal reversed. -
Page 16: Reference
Reference 2PC / 2PCKA *Specifications and ratings are subject to change without prior notice. Ratings T2PC / T2PCKA S3003 Transmitter Servo (2 channels, AM transmitter) (standard servo) Transmitting frequency: Power requirement: 27, 29, 40, 41, 72 or 75 MHz 4.8V or 6V (common with receiver) -
Page 17: Troubleshooting
If your digital proportional R/C set does not operate, its range is short, it intermit- tently stops operating, or it operates erroneously, take the action shown in the table below. If this does not correct the trouble, please contact a Futaba dealer. Check point... -
Page 18: Repair Service
If you are still having trouble, pack up your system in its original shipping materials and send it to your nearest authorized Futaba R/C Service Center. Be sure to include a note in your package that describes the trouble in as much...