THROTTLE CUT
Throttle cut provides an easy way to stop the
at idle. The action is not functional at high throttle
to avoid accidental dead sticks. The switch's
location and direction must be chosen, as it defaults
to NULL.
[Return Key]
Throttle cut setting procedure
*Perform the following settings before using the cursor lever
to move the cursor to the item to be set.
(For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.)
PUSH
(When the enter button is pressed, the servo operation
position is reset to the initial value.)
*With the selected cut switch ON and the throttle stick at idle;
adjust the rate until the engine consistently cuts off.
However, be sure that the throttle linkage does is not pulled
too tight and unreasonable force is not applied to the servo.
<Functions of Linkage Menu>
[Cursor Lever]
[Data Input Dial]
[Enter Button]
61