Automatic Top Threading - ELNA XQUISIT 2 Manual

A
3
1
2
3
A
4
1
2
1

Automatic Top Threading

NOTE: Close face plate cover. Never open face
plate cover when automatic top threading is in
process.
NOTE: Check needle size. Use only size
11/75 – 16/100 (excluding twin and
hemstitch/wing needles) for automatic top
threading. Any other size needle requires manual
threading. See page 24.
NOTE: Check that needle is pushed up as far as it
will go.
NOTE: Some specialty threads will require
manual threading.
Turn on power/light switch and touch Welcome
screen.
1. Lower presser foot. Press the
needle is raised. Place spool of thread on spool
pin and firmly attach spool cap. See page 20.
2. Using both hands, pull thread into groove of
thread sensor guide.
3. Hold thread with right hand while left hand pulls
thread through groove towards back of machine.
Cut using mounted top thread cutter A.
4. Touch key.
NOTE: If the thread is caught on the hook,
remove it before sewing.
key until the
23