Invisible Zipper - ELNA XQUISIT 2 Manual

A
A
B
B

Invisible Zipper

NOTE: Do not stitch any section of the seam
before inserting zipper.
NOTE: Change to left needle position - 0.0.
1. Open zipper. Place zipper face down and, using
a low temperature setting, press zipper teeth
flat.
2. Pin right side of zipper to right side of fabric
with teeth on seam line and zipper top stop 2
cm (3/4") from fabric top edge. Place zipper and
fabric under foot with right groove of foot over
teeth. Sew down length of zipper to slider.
Reverse sew.
A Right side of fabric
3. Pin and sew other side of zipper using same
method but with left groove of foot.
B Wrong side of fabric
4. Close zipper. Attach regular zipper foot B with
right side pin and change needle position to
3.6. Pull zipper end to the left and lower needle
into fabric about 0.3 cm (1/8") to the left of last
stitches. Lower foot, lockstitch and sew
remaining seam length.
5. Press seam open and tack bottom ends of
zipper to seam allowance as shown.
51