Do you have a question about the 5200 and is the answer not in the manual?
Questions and answers
Brenda Hooper
April 20, 2025
How to thread the bobbin
1 comments:
Mr. Anderson
May 10, 2025
To thread the bobbin for the ELNA 5200:
1. Set the speed control lever to the bobbin winding position. 2. Guide the thread around the thread guide. 3. Pass the thread through the hole in the bobbin from inside to outside. 4. Place the bobbin on the bobbin winder spindle. 5. Push the bobbin winder spindle to the right (the indicator will show winding mode). 6. Hold the thread end and press the foot control; stop after a few spins. 7. Cut the thread close to the hole in the bobbin. 8. Press the foot control again to continue winding. 9. The bobbin stops automatically when full. 10. Release the foot control.
This answer is automatically generated
Mary Selph
April 10, 2025
How to adjust width and length of zigzag stitch on 5200 Elna?
1 comments:
Mr. Anderson
April 10, 2025
To adjust the width and length of the zigzag stitch on the ELNA 5200:
1. Activate stitch width mode by pressing the mode key. The stitch width can then be adjusted between 0.0 and 7.0 using the plus or minus keys. 2. To adjust stitch length, press the mode key again to switch to stitch length adjustment (the middle green light turns on). The preset value is "5.0", and it can be changed using the plus or minus keys.
Need help?
Do you have a question about the 5200 and is the answer not in the manual?
Questions and answers
How to thread the bobbin
To thread the bobbin for the ELNA 5200:
1. Set the speed control lever to the bobbin winding position.
2. Guide the thread around the thread guide.
3. Pass the thread through the hole in the bobbin from inside to outside.
4. Place the bobbin on the bobbin winder spindle.
5. Push the bobbin winder spindle to the right (the indicator will show winding mode).
6. Hold the thread end and press the foot control; stop after a few spins.
7. Cut the thread close to the hole in the bobbin.
8. Press the foot control again to continue winding.
9. The bobbin stops automatically when full.
10. Release the foot control.
This answer is automatically generated
How to adjust width and length of zigzag stitch on 5200 Elna?
To adjust the width and length of the zigzag stitch on the ELNA 5200:
1. Activate stitch width mode by pressing the mode key. The stitch width can then be adjusted between 0.0 and 7.0 using the plus or minus keys.
2. To adjust stitch length, press the mode key again to switch to stitch length adjustment (the middle green light turns on). The preset value is "5.0", and it can be changed using the plus or minus keys.
This answer is automatically generated