Changing The Light Bulbs - ELNA XQUISIT 2 Manual

1
B
A
3
5
1
3
156
C
2
B
4
2
4

Changing the Light Bulbs

NOTE: Allow light bulb to cool before removing.
Light above Needle Area
1. Open face plate cover. Remove screw A and lift
out bulb mounting base B.
2. Remove bulb base C from bulb mounting base
B.
3. Pull out light bulb; do not twist bulb.
4. Align new light bulb with grooves in bulb base
and push bulb into place.
5. Fit mounting base over bulb base, aligning
groove. Place mounting base into original
position and replace screw. Close face plate
cover.
Light Above Sewing Area
1. Remove cover.
2. Pull out light bulb; do not twist bulb.
3. Align new light bulb with grooves in bulb base
and push bulb into place.
4. Replace cover.
NOTE: Replace either bulb with the same type
bulb rated 13.5 volts, 3 watts.