Built-In Needle Threader - ELNA eXcellence 740 Manual

z
x
3
c
v
1
2
4
4
2
5

Built-in needle threader

NOTE:
The needle threader can be used with a #11 to #16
needle, or a #11 Blue needle.
Thread size 50 to 90 is recommended.
z Lower the presser foot. Raise the needle to its
highest position. Turn the power switch off.
Pull down the needle threader knob as far as it will go.
The threader hook comes out through the needle eye
from behind.
1 Knob
2 Threader hook
x Draw the thread from the left to the right, under the
left guide, threader hook and the right guide.
Draw the thread around the right guide toward you.
3 Left guide
4 Right guide
c Raise the threader slowly so a loop of the thread is
pulled up through the needle eye.
5 Thread loop
v Pull the thread end through the needle eye.
NOTE:
The needle threader cannot be used with the twin needle.
36