System Statistics Screen - ZyXEL Communications NWA-3160 - V3.70 Manual

Chapter 4 Status Screen

4.2.1 System Statistics Screen

Use this screen to view diagnostic information about the NWA. Click Show
Statistics in the Status screen. The following screen pops up.
Note: The Poll Interval field is configurable. The fields in this screen vary according to
the current wireless mode of each WLAN adaptor.
Figure 55 System Status: Show Statistics
The following table describes the labels in this screen.
Table 9 System Status: Show Statistics
LABEL
Port
Status
TxPkts
RxPkts
Collisions
Tx B/s
Rx B/s
Up Time
WLAN1
Bridge Link #
Active
84
DESCRIPTION
This is the Ethernet port (LAN) or wireless LAN adaptor (WLAN).
This shows the port speed and duplex setting if you are using
Ethernet encapsulation for the Ethernet port. Ethernet port
connections can be in half-duplex or full-duplex mode. Full-duplex
refers to a device's ability to send and receive simultaneously, while
half-duplex indicates that traffic can flow in only one direction at a
time. The Ethernet port must use the same speed or duplex mode
setting as the peer Ethernet port in order to connect.
This shows the transmission speed only for the wireless adaptors.
This is the number of transmitted packets on this port.
This is the number of received packets on this port.
This is the number of collisions on this port.
This shows the transmission speed in bytes per second on this port.
This shows the reception speed in bytes per second on this port.
This is total amount of time the line has been up.
This section displays only when wireless LAN adaptor WLAN1 is in AP
+ Bridge or Bridge / Repeater mode.
This is the index number of the bridge connection.
This shows whether the bridge connection is activated or not.
NWA-3160 Series User's Guide