Cisco 7971G-GE - IP Phone VoIP Administration Manual page 92

Device Configuration Menu
The phone also has a Network Configuration menu that you access directly from the Settings menu. For
Note
information about the options on that menu, see the
Table 4-18 Network Configuration Menu Options
Option
Load Server
RTP Control Protocol
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 7.0
4-26
Description
Used to optimize installation time for phone firmware
upgrades and offload the WAN by storing images locally,
negating the need to traverse the WAN link for each phone's
upgrade.
You can set the Load Server to another TFTP server IP address
or name (other than the TFTP Server 1 or TFTP Server 2)
from which the phone firmware can be retrieved for phone
upgrades. When the Load Server option is set, the phone
contacts the designated server for the firmware upgrade.
The Load Server option allows you to specify an
Note
alternate TFTP server for phone upgrades only. The
phone continues to use TFTP Server 1 or TFTP Server
2 to obtain configuration files. The Load Server option
does not provide management of the process and of
the files, such as file transfer, compression, or
deletion.
Indicates whether the phone supports the Real-Time Control
Protocol (RTCP). Settings include:
Enabled
•
Disabled—default
•
If this feature is disabled, several call statistic values display
as 0. For additional information, see the following sections:
Call Statistics Screen, page 7-13
•
Streaming Statistics, page 8-10
•
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
"Network Configuration Menu" section on page
To Change
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
4-5.
OL-15299-01