Configuring The Cisco Unified Wireless Ip Phone 7925G, 7925G-Ex, And 7926G - Cisco 7925G Deployment Manual

Unified wireless ip phone
Hide thumbs Also See for 7925G:
Table of Contents

Advertisement

When using Cisco Autonomous Access Points, use a dedicated native VLAN. The Cisco Autonomous Access Points utilize
Inter-Access Point Protocol (IAPP), which is a multicast protocol.
For the native VLAN, it is recommended not to use VLAN 1 to ensure that IAPP packets are exchanged successfully.
Ensure that Public Secure Packet Forwarding (PSPF) is not enabled for the voice VLAN as this will prevent clients from
communicating directly when associated to the same access point. If PSPF is enabled, then the result will be no way audio.
Port security should be disabled on switch ports that Cisco Autonomous Access Points are directly connected to.
The network ID in the SSID configuration the Cisco Autonomous Access Point should only be disabled if Layer 3 mobility is
enabled where the Wireless LAN Services Module (WLSM) is deployed.
Configuring the Cisco Unified Wireless IP Phone 7925G, 7925G-EX,
and 7926G
There are various methods for configuring network settings on the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and
7926G.
Configuring Phones with the Keypad
The network profiles can be configured by navigating to Settings > Network Profiles.
It may be required to unlock the screen by pressing **#.
For more information, refer to the Configuring Settings on the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and
7926G in the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide at this URL:
http://www.cisco.com/en/US/products/hw/phones/ps379/prod_maintenance_guides_list.html
Configuring Phones with the Web Interface
The Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G have an HTTPS enabled web interface that can be
accessed via the 802.11a/b/g radio or USB.
A PC running Microsoft Windows 7® 64 bit, Windows 7® 32 bit, Windows XP 32® bit or Windows 2000® 32 bit is required
to utilize the USB interface on the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G.
If using USB, then set a static IP on the PC's USB network interface (e.g. 192.168.1.X /24).
In order to make configuration changes via the web interface, then web access must be set to Full, which will also enable a few
additional menus.
Log into the administration web pages by using these defaults:
username = admin / password = Cisco
The USB driver installation packages for Microsoft Windows 7 64 bit, Windows 7 32 bit, Windows XP 32 bit, and Windows
2000 32 bit are available for download at the following URL.
http://software.cisco.com/download/navigator.html?mdfid=278875240
Note: It is not recommended to use the 192.168.1.0 /24 network for the wireless LAN interface as that network is used by the
USB interface by default. If wanting to use the 192.168.1.0 /24 network for the wireless LAN, then either change the USB IP
address on the phone or do not charge the phone via USB.
Configuring Phones with the Bulk Deployment Utility
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
89

Advertisement

Table of Contents
loading

This manual is also suitable for:

7925g-ex7926g

Table of Contents