Bluetooth Module - HP 2710p - Compaq Business Notebook Maintenance And Service Manual

Reverse this procedure to install the audio connector board.

Bluetooth module

Description
Bluetooth (includes cable)
Before removing the Bluetooth module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive compartment cover (see
b. Keyboard (see
c. Rear plastic bezel (see
d. Top cover (see
e. Audio connector board (see
Remove the Bluetooth® module:
1. Disconnect the Bluetooth module cable (1) from the system board.
2. Remove the Bluetooth module cable from the clips (2) built into the base enclosure. The Bluetooth
module cable is included with the Bluetooth module and is also available in the Cables Kit, spare
part number 454682-001.
3. Remove the Phillips PM2.0×5.0 screw (3) that secures the Bluetooth module to the base enclosure.
Battery on page 39).
Hard drive on page
Keyboard on page 50)
Rear plastic bezel on page
Top cover on page 54)
Audio connector board on page
Spare part number
454691-001
41)
52)
58)
Component replacement procedures 59