Fan/Heat Sink Assembly - HP 2710p - Compaq Business Notebook Maintenance And Service Manual

●
Thin foil-type strip that fits onto the heat shield atop the system board, spare part number
459912-001.
To install the strip, place it into the slot on the heat shield, making sure the strip is under the tabs
in the slot.

Fan/heat sink assembly

Description
Fan/heat sink assembly (includes replacement thermal material)
Before removing the fan/heat sink assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a.
b.
c.
d.
e.
f.
68 Chapter 4 Removal and replacement procedures
Battery on page
Hard drive compartment cover (see
Keyboard (see Keyboard on page
Rear plastic bezel (see
Top cover (see Top cover on page
Display assembly (see
System board (see System board on page
39).
Hard drive on page
50)
Rear plastic bezel on page
54)
Display assembly on page
65)
Spare part number
454692-001
41)
52)
62)