HP 2710p - Compaq Business Notebook Maintenance And Service Manual page 65
Hp compaq 2710p notebook pc - maintenance and service guide
Hide thumbs
Also See for 2710p - Compaq Business Notebook:
- Maintenance and service manual (134 pages) ,
- Getting started (58 pages) ,
- User manual (26 pages)
Table of Contents
Advertisement
2.
Remove the following:
(1) One small Mylar screw cover. All Mylar screw covers detailed in this section are included in the
Rubber Kit, spare part number 454686-001.
(2) Three Torx T8M2.0×8.0 screws.
(3) Two large Mylar screw covers. The screw covers detailed in this section are included in the
Rubber Kit, spare part number 454686-001.
(4) Two Torx T8M2.0×4.0 screws.
3.
Turn the computer right-side up, with the front toward you.
4.
Open the computer as far as possible.
5.
Release the ZIF connector (1) to which the LED board cable is connected and disconnect the LED
board cable from the system board.
6.
Remove the two Phillips PM2.0×5.0 screws (2) that secure the top cover to the computer.
7.
Lift the front edge of the top cover (3) until it rests at an angle.
Component replacement procedures
55
Advertisement
Table of Contents
