Modem Module - HP 2710p - Compaq Business Notebook Maintenance And Service Manual

Modem module

NOTE: All modem module spare part kits include a modem module cable.
Description
For use in all countries and regions except Australia, Brazil, and New Zealand
For use only in Australia and New Zealand
Before removing the modem module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive compartment cover (see
b. Keyboard (see
c. Rear plastic bezel (see
d. Top cover (see
e. Display assembly (see
f. System board (see
Remove the modem module:
1. Turn the system board upside down, with the front toward you.
2. Remove the two Phillips PM2.5×4.0 screws (1) that secure the modem module to the system board.
3. Lift the modem module (2) straight up to disconnect it from the system board.
Battery on page 39).
Hard drive on page
Keyboard on page 50)
Rear plastic bezel on page
Top cover on page 54)
Display assembly on page
System board on page
41)
52)
62)
65)
Component replacement procedures
Spare part number
443899-001
443899-011
71