Server Chassis Features - Supermicro SUPERSERVER 5015P-8R User Manual

Serial ATA [5015P-T(R)]
The PDSMP-i uses an SATA controller integrated in the ICH7R portion of the
chipset to provide a four-port Serial ATA subsystem, which is RAID 0, 1, 5 and 10
supported. The SATA drives are hot-swappable units.
Notes: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the Serial ATA drives.
Onboard Controllers/Ports
One fl oppy drive controller and a single-channel ATA/100 controller are provided to
support up to two IDE hard drives or ATAPI devices. A second IDE slot can be used
for compact fl ash cards (only). The color-coded I/O ports include one COM port, a
VGA (monitor) port, two USB 2.0 ports, PS/2 mouse and keyboard ports and two
gigabit Ethernet ports. An external SCSI port is also included on the PDSMP-8.
ATI Graphics Controller
Both serverboards feature an integrated ATI video controller based on the Rage
XL graphics chip. Rage XL fully supports sideband addressing and AGP texturing.
This onboard graphics package can provide a bandwidth of up to 512 MB/sec over
a 32-bit graphics memory bus.
Other Features
Other onboard features that promote system health include onboard voltage moni-
tors, a chassis intrusion header, auto-switching voltage regulators, chassis and CPU
overheat sensors, virus protection and BIOS rescue.
1-3

Server Chassis Features

The SuperServer 5015P-8(R)/5015P-T(R) is built upon the SC816S-400(R)/
SC816T-400(R) 1U server chassis. The following is a general outline of the main
features of the SC816S-400(R)/SC816T-400(R) chassis.
System Power
The 5015P-8 and the 5015P-T feature a single 400W cold-swap power supply.
Power must be removed from the system before servicing or replacing the power
supply.
Chapter 1: Introduction
1-3