Wren Kitchens Infinity BASE UNIT Fittings Manual page 6

No screws or wall plugs are provided for attaching the unit to the wall.
Before drilling into the wall you MUST check for any hidden services or pipework within the walls.
Attaching the wall hanging bracket to the
wall
Position the 2x hanging brackets as shown
and mark the holes onto the wall.
Remove the hanging bracket, then drill holes
into the wall of an appropriate size for the
screws required
Attach the hanging bracket onto the wall by
screwing through the holes on the hanging
bracket into the holes on the wall.
In order for to complete the steps below the red screw found on the wall unit on the hanging
Lifting the unit into place
Lift the unit against the wall slightly higher
than its finished height. Lower the unit down
onto the wall hanging bracket.
Before releasing the unit, gently tug it
to ensure it is securely supported by the
hanging brackets.
This is due to variations in wall construction.
bracket will need to be screwed all the way out.
Page 6