For Your Safety; Some Technical Data - Cuisinart DLC-10C - Classic Original Food Processor Use And Care Manual

Chopping certain foods may
scratch or cloud the work bowl.
Among them are ice, whole spices
and oils like wintergreen. If you like
to prepare your own spice blends,
you may want to keep a second
bowl just for that purpose.
The base housing is made of a
tough plastic with high impact
resistance. Its smooth surface will
look new for years. Keep a sponge
handy as you work and wipe spills
from the base.
Four rubber feet on the underside
keep the base from moving on most
work surfaces when the machine is
processing heavy loads. If the feet
leave spots on the counter, spray
them with a spot remover like
Fantastik or K2-R and wipe with a
damp sponge. If any trace of the
spot remains, repeat the procedure
and wipe the area with a damp
sponge and non-abrasive cleaning
powder.
To clean the inside of the
detachable stem, slide the stem
release button on the side up as far
as it will go and hold it there as you
run water through the stem.
IMPORTANT: Never store any
blade or disc on the motor shaft.
No blade or disc should be placed
on the shaft except when the
processor is about to be used.

FOR YOUR SAFETY

Like all powerful electrical
appliances, a food processor
should be handled with care.
Follow these guidelines to protect
you and your family from misuse
lhat could cause injury.
► Handle metal blade and discs
carefully. Their cutting edges are
very sharp.
► Always place disc on flat stable
surface before connecting
detachable stem.
► Never put blade or disc on motor
shaft until work bowl is locked in
place.
►Always be sure that blade or disc
is down on motor shaft as far as it
will go.
►Always insert metal blade in work
bowl before putting ingredients in
bowl.
►When slicing or shredding food,
always use pusher. Never put your
fingers or a spatula into feed tube.
► Always wait for blade or disc to
stop spinning before you remove
pusher assembly or cover from
work bowl.
► Always remove work bowl from
base of machine before you remove
metal blade or dough blade.
► Be careful to prevent metal blade
from falling out of work bowl when
emptying bowl. Remove it before
tilting bowl, or hold it in place with
your finger, a spatula or a spoon.
► Do not use pusher assembly if
sleeve becomes detached from
pusher. Call Cuisinart Owner
Service immediately. Our toll-free
number is listed in the warranty.

SOME TECHNICAL DATA

The motor in your food processor
operates on standard line operating
current. The appropriate voltage
and frequency for your machine are
shown on a label under the base.
An automatic, temperature-
controlled circuit breaker in the
motor ensures complete protection
against motor burnout. If the
processor runs for an exceptionally
long time when chopping, mixing
or kneading a thick or heavy
mixture in successive batches, the
motor may overheat. If this
happens, the processor will stop.
Turn it off and wait for the motor to
cool off before proceeding. II will
usually cool off within 10 minutes.
In extreme cases, it could take an
hour.
Safety switches prevent the
machine from operating when the
work bowl or the cover is not
locked into position. The motor
stops within seconds when the
motor is turned off, and a fast-stop
circuit stops it instantly when the
pusher assembly is unlocked.
25
-