FP PostBase Fusion Installation And Safety page 21

Step 7: Installing the PostBase Fusion Feeder (optional)
Ramp
Caution! Only connect the Feeder once the
PostBase Fusion franking machine is fully
installed. Otherwise the PostBase Fusion
will not recognise the feeder. The will not
work.
Turning off the franking machine
• Press the ON/OFF button for
3 seconds
The PostBase Fusion will complete any cur-
rent actions, return the display to its home
position, and then turn itself off.
Setting up the feeder
Feeder
• Place the ramp, feeder and franking
• When assembling, ideally proceed from
The components are mechanically coupled
with catches (each on the right housing side)
and slots (each on the underside at the left)
Installation and commissioning
three seconds.
machine as shown in the illustration above.
left to right (starting at the ramp).
21
PostBase Fusion
franking machine