Checking Clutch Operating Fluid Level; (Inspections Ii And Iii) - BMW R1150RT - MAINTENANCE INTEGRAL ABS Maintenance Manual

•
Correct the brake fluid level.
•
Wipe the rim of the reservoir, the rubber dia-
phragm and the cover to remove brake fluid, and
carefully reassemble the components.
– Place the motorcycle on its centre stand.
Required level
not below ......................................................... MIN
e
Attention:
After all the work on the brake system has been
completed, run a bleed test using the
BMW MoDiTeC.
•
Perform bleed test with BMW MoDiTeC.
( 00.29)
a
•
Install fuel tank.
Brake fluid....................................................DOT 4
Checking clutch operating fluid
level

(Inspections II and III)

e
Attention:
Keep the brake fluid in the clutch operating system
away from painted surfaces on the motorcycle be-
cause brake fluid attacks paint.
•
Place motorcycle on its centre stand.
•
Move the handlebars to the straight-ahead
position.
R22000150
Required level with a new clutch liner:
........................................... Half way up sight glass
L
Note:
As the clutch lining wears, the fluid level in the res-
ervoir rises.
•
If necessary, remove reservoir cap with insert.
•
Correct the fluid level.
– Mark in reservoir: same as brake circuit.
•
Reinstall the reservoir cap with insert.
•
Tighten the reservoir cap carefully and without
using force.
Brake fluid ...................................................DOT 4
R22000190
00.51