Additionally With [Abs]; Checking Clutch Operating Fluid Level; (Inspections I, Ii And Iii) - BMW R 1200 C Repair Manual

Additionally with [ABS]

•
Connect the brake bleeding device to the bleed
screw on the pressure modulator for the rear
brake (arrow); this is marked HR.
•
Open the bleed screw by half a turn.
e
Caution:
During brake bleeding, make sure that the fluid re-
plenishing hole is always below the level of the brake
fluid, or else air will be drawn into the brake system.
If this occurs, repeat the bleeding operation.
•
Draw off brake fluid until it emerges clear and
free from air bubbles.
•
Close the bleed screw.
•
If necessary, repeat the bleeding procedure.
Brake fluid grade .........................................DOT 4
X
Tightening torque:
Bleed screw at pressure modulator................ 9 Nm
00.24
Checking clutch operating fluid
level

(Inspections I, II and III)

e
Caution:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle, because brake fluid
destroys paint.
•
Place the motorcycle on the auxiliary stand,
BMW No. 00 1 550.
•
Turn the steering to the right.
C000190
e
Caution:
With the clutch lining in new condition the surface of
the fluid (arrow) must be up to the lower edge of the
ring mark; it must not be below normal.
L
Note:
As the clutch lining wears, the fluid level in the res-
ervoir rises.
•
If necessary, take off reservoir cover with insert.
•
Correct the fluid level. Mark in reservoir: as for
brake circuit.
•
Re-attach the reservoir cover with insert.
•
Tighten the reservoir cover without using force.
Brake fluid grade .........................................DOT 4
CUB0100