BMW R1150RT - MAINTENANCE INTEGRAL ABS Maintenance Manual Page 70

Hide thumbs

Advertisement

2
Disassembling and assembling
34 21
rear brake caliper
Disassembling rear brake caliper
Integral ABS Drain rear wheel circuit (
Remove the brake caliper.
Close the bleed screw.
Hold a cloth over the brake caliper piston.
Carefully press out brake piston (3) with a com-
pressed air gun applied to the connecting bore;
work at low air pressure.
e
Attention:
Keep fingers away from gap between piston and
side contact face of brake pads; risk of injury.
Remove sealing rings (4) from left and right
bores.
Inspect the brake caliper piston for hairline
cracks, score-marks and other damage.
X
Tightening torque:
Bleed screw to brake caliper .......................... 5 Nm
1
5
Assembling rear brake caliper
Coat the new sealing rings with brake fluid and
insert them into the left and right brake caliper
bores.
Coat both brake caliper pistons with brake fluid
34.17).
and install them.
a
e
Attention:
Keep the brake pistons parallel with their bores
when installing.
Coat the adapter plate locating pins with
Shell Retinax A and install the adapter plate.
Insert locating plate (5) into brake caliper.
L
Note:
The installed position must be correct (arrow point-
ing in forward-travel direction).
Using piston resetting tool, BMW No. 34 1 531,
press the pistons fully back.
Integral ABS Fill and bleed rear wheel circuit
(
34.26).
a
X
Tightening torque:
Brake caliper to rear wheel drive .................. 40 Nm
Brake hose to brake caliper ......................... 18 Nm
Bleed screw to brake caliper .......................... 5 Nm
3
4
R21340010
34.7

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments:
  • GHGHGH Feb 04, 2015 09:08:
    MUY UTIL MUY BIEN, MUY UTIL MUY BIEN, MUY UTIL MUY BIEN