34 21 200 Brake pads, rear brake
Integral brakes, the front brake must be ready for
Remove keeper (arrow) from retaining pin.
Drive the retaining pin out towards the wheel
Remove brake caliper.
Remove brake pads.
Integral ABS Press back pistons in brake caliper
brake pad only far enough to allow the brake disc to
the slipped in.
Make sure that the fluid level in the wheel-circuit res-
ervoir does not rise above "max".
Risk of fluid escaping.
If fluid escapes, proceed in accordance with "in-
structions for filling reservoir".
Force back the pistons.
Check that spring is correctly positioned and se-
Engraved arrow (arrow) points in direction of
Installation is the reverse of the removal proce-
Check operation of the brake system with the ig-
nition switched on.
Brake caliper to rear wheel drive .................. 40 Nm