Integral Abs; Reading Fault Memory With Bmw Moditec; Performing Bleed Test With Bmw Moditec - BMW R1150RT - MAINTENANCE INTEGRAL ABS Maintenance Manual

Table of Contents

Advertisement

Install rear brake pads and brake caliper.
Disconnect the container from the wheel-circuit
reservoir.
Hand-tighten cap of rear wheel-circuit reservoir.
Check operation of the brake system with the ig-
nition switched on.
e
Attention:
After all the work on the brake system has been
completed, run a bleed test using the
BMW MoDiTeC.
Perform bleed test with BMW MoDiTeC.
Install fuel tank.
Brake fluid....................................................DOT 4
X
Tightening torque:
Bleed screw in rear brake caliper ................... 5 Nm
Brake caliper to rear wheel drive .................. 40 Nm

Integral ABS

34 00
Reading fault memory with
BMW MoDiTeC
Remove front and rear seats.
Connect the BMW MoDiTeC to the diagnosis
connector.
Read out the fault memory.
Clear the fault memory if applicable, or perform
all requisite repair work.
Integral ABS
34 00
Performing bleed test with
BMW MoDiTeC
Remove front and rear seats.
Connect the BMW MoDiTeC to the diagnosis
connector.
d
Warning:
When performing maintenance and repair work on
BMW Integral ABS, never pump quickly or
vigorously.
Perform bleed test.
Perform all requisite repair work.
34.29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R 1150 rt

Table of Contents