Sharp MultiSync ME982 User Manual page 20

The Main Power switch must be in the ON position in order to power up the monitor using the POWER ON button on the remote
control or the POWER button on the Control Panel.
Main Power Switch
ON OFF
nOperations after first power-on
When you turn on the power for the first time, the initial setting screen appears. Navigate the cursor to [Start] using the
▲/▼ buttons on the remote control and press the SET button to start. Configure the initial settings, such as setting the
language, date and time, etc.
Power ON and OFF
Press the ⏻ button on the Control Panel or POWER ON button on the remote control to turn on the monitor.
Press the POWER button again on the monitor or press the STANDBY button on the remote control. The power is turned off.
(Standby state)
The monitor's power LED indicates the current status of the monitor. Please refer to the following table for information about the
power indicator.
Power indicator status
and lighting pattern
Glowing blue Normal
Blinking green* Under any of the conditions below, no input signal has
1
been detected by the monitor during the period of time
you set:
•
•
•
•
•
* : Time setting for auto power save is available at [Power Save Settings] (See
1
* : [Mode] in [Power Save Settings] is set to [Normal].
2
Turning Power On/Off
Condition
Connecting a cable to the USB Type-C port and [USB
Power] is set to [Auto].
[USB Power] is set to [On].
[Auto Input Change] is set to a setting except for
[None].
[Quick Start] is enable.
Under the [Lock Settings], [Key] or [Key & IR] is set
to [Select] and [All Lock] or [Custom Lock] is set to
[Mode].
⏻ Button
page 66).
English−20
Recovery
1. Turn on the monitor using the remote
control or the monitor button.
2. Send an AV signal input to the monitor.