Sharp MultiSync ME982 User Manual page 52

The USB Hub does not operate
• Check to make sure that the USB cable is properly
connected. Refer to your USB device user's manual.
• Check that the USB upstream port on the monitor is
connected to the USB downstream port on the computer.
Please make sure the computer is ON or [USB Power]
is [On].
USB or RS-232C or LAN control is not available
• Check RS-232C (reverse type) or the LAN cable.
A category 5 or higher LAN cable is required for
connection.
nPower Indicator Patterns
LED on the monitor is not lit (no blue or red color can
be seen) (see page 20)
• Make sure the power cord is properly connected to the
monitor and the wall, and make sure the monitor's main
power switch is ON.
• Make certain the computer is not in a power-saving
mode (touch the keyboard or move the mouse).
• Check that the [Power Indicator] is set to [On] in the
[Protect] settings of the OSD menu.
The monitor goes into standby automatically
• Set the [CEC] function to [Off]. The monitor may go into
standby state when a connected HDMI-CEC supported
device goes into standby.
• Please check [Power Off Schedule] in the [Schedule
List].
MediaPlayer function does not recognize the USB
storage device
• Check that a USB storage device is connected to the
USB port.
• Check the file format of the USB storage device if it is
not recognized by the monitor.
LED colors, except for blue, are blinking or glowing
• A certain failure might have occurred, please contact
your supplier.
• If the monitor is powered off due to the internal
temperature being higher than the normal operating
temperature, the LED will blink red six times. Please
leave the monitor to cool down for a few minutes then
turn it on again.
• The monitor could be in standby.
Press the power on button on the remote control or
press the ⏻ button on the monitor.
English−52