Installing A Memory Module - NEC VERSA TXI Manual
Hide thumbs
Also See for VERSA TXI:
- Manual (8 pages) ,
- Release note (8 pages) ,
- Important information (2 pages)
Table of Contents
Advertisement
When the edge of the memory module pops up and is at approximately a 60 degree
5.
angle, pull it from the socket.
Installing a Memory Module
Follow these steps to replace a memory module.
Locate the connectors and alignment notch on the new memory module.
1.
Locate the memory module connector. Hold the memory module at a 45-degree
2.
angle and align the memory module contacts with the socket in the system. Push
the connector into the socket.
Press down on the edge of the memory module opposite the contacts until the
3.
locking tabs on the sides snap into place, securing the module.
5-12 Using the System Drives and Bays
Removing a memory module
A – Memory Module Locking Tabs
Advertisement
Table of Contents
