Running The Phdisk Utility - NEC VERSA TXI Manual

drivers have been installed, and that no device listed in Device Manager is flagged with
a yellow exclamation point.
If not, Hibernate does not work correctly, and your hard drive may become corrupted.

Running the PHDISK Utility

Follow these steps to run the PHDISK utility.
With system power on, insert the NEC Application and Driver CD in the CD-ROM
1.
or DVD-ROM drive. For more information on using the Application and Driver
CD, see "NEC Application and Driver CD" in this chapter.
Select the PHDISK utility for installation. Follow the prompts to install the
2.
appropriate files on your hard drive.
Once the files have been installed, exit the Application and Driver CD interface
3.
and remove the CD.
Restart your system in MS-DOS mode by pressing Start and clicking Shutdown.
4.
Select 'Restart in MS-DOS mode' and click OK.
At the MS-DOS prompt, type
5.
\necutils\phdisk directory.
Type
6.
following valid options:
Enter 2 and press
7.
similar to the following appears:
(The minimal size varies according to the amount of system memory installed in
your system.)
Press Enter to accept the minimal size. A file large enough to accommodate your
8.
system's memory is created on the hard disk drive, and the PHDISK utility
interface appears again.
Enter 3 (for Reboot) and press Enter.
9.
If necessary, press any keyboard key when prompted to reboot the system.
10.
4-8 Using the Operating System and Utilities
Before running the PHDISK utility, verify that all appropriate
and press
phdisk Enter
1. Create Partition
2. Create File
3. Reboot
4. Exit
. (Be careful not to select Create Partition.) A prompt
Enter
Please input size (Minimal: 74179) KB:
cd \necutils\phdisk
. The PHDISK utility interface appears with the
and press to change to the
Enter