Post Error Messages - NEC VERSA V User Manual

If an error message appears before the operating system
starts, look up the error message in the following table.
Follow the instructions. If you see other error messages, the
hardware might need repair.
NOTE: When the Versa detects an error related to
display devices, it cannot display on either the LCD
or a CRT. The system warns you by beeping.
MESSAGE
Diskette drive n failure
No boot device available
— press F1 to run Auto
Setup
Invalid configuration
information — run
Setup program
6-4 Problem Solving

POST Error Messages

WHAT TO DO
Drive n does not work or is not properly
connected. ( n is 0 or 1. Drives 0 and 1 refer to
drives A and B.)
Check that drive n is securely connected and
power is on.
Press F1 to start Auto Setup to check the diskette
drive parameters.
If there's still a problem, drive n might need repair.
Diskette read failure — Remove the diskette from
drive A and press F1 to run Auto Setup. Press any
other key to retry boot, or start the system from
the hard disk.
Or, insert a bootable disk in drive A and press F1.
Press F1 to start Auto Setup. Change the hard
disk type to the correct setting. Exit and save
Auto Setup.
One or more system configuration parameters
are not properly set. Start Auto Setup, set
them correctly, and exit and save to update
the parameters.
Replace the CMOS lithium battery.