NEC VERSA 2600 User Manual page 126

MESSAGE
Diskette drive failure
Diskette read failure
No boot device available
Invalid configuration
information – run SCU
Real time clock failure
Time-of-day not set
Fixed disk configuration
error
7-4 Solving Problems
POST Error Messages
WHAT TO DO
The diskette drive does not work or is not properly
connected.
Check that the drive is securely connected and
power is on.
Run the SCU to check the diskette drive
parameters.
If problem persists, the drive might need repair.
Remove the diskette from the drive and try another
diskette. If you cannot read from the next diskette,
your drive might need repair.
Go into the SCU and check the hard disk type
defined. Unless you had a different hard disk
installed, the setting should be "Auto." Correct the
setting.
Start the SCU, check the system parameters set,
and correct them. Exit and save the parameters
set.
Connect the AC adapter to charge the internal
backup battery. Restart the SCU and set the
correct parameters.
Set the time and date using the SCU. Exit and
save to update the parameters.
Connect the AC adapter to charge the internal
backup battery.
Run SCU and set the time and date. Exit SCU and
save to update the time and date.
Start the SCU. Check that the hard disk type
specified is "Auto." If not, change it to Auto under
the Hard Disk option in the Standard menu. Exit
and save to update the parameters. If a problem
still exists, the hard disk might need repair.