Installing The Battery Pack; How To Recharge The Battery Pack - NEC VERSA 2600 User Manual

When remaining battery power falls to 10%, the system
emits a single beep; when battery power falls to 5%, the
system beeps once every 60 seconds.

Installing the Battery Pack

Install the battery pack in your system as follows. (For in-
formation about replacing a battery pack, see "Replacing
the Battery Pack," later in this section.)
Be sure to save your data before replacing the bat-
tery pack or connecting the AC adapter. Failure to
do so can result in data loss.
1. If your system is on, save your data, close any applica-
tions running, and power off the system.
2. Align the battery pack with the Battery Pack bay. Make
sure the battery contacts are aligned properly with the
connector inside the bay. Install the battery pack only in
this bay.
Push the battery pack into the bay until the locking latch
3.
on the bottom of the system clicks into place.

How to Recharge the Battery Pack

When battery power gets low, proceed as follows:
1. Connect your system to the AC adapter and AC power
to recharge the battery pack . Your system is again
ready for use and will recharge as being used. The re-
charge time will be about the same, no matter if powered
"on" of powered "off." (see "Using the AC Adapter")
1-16 Getting Started
!
CAUTION
or