Table of Contents
Advertisement
1.
Locate the screw on the front of the system between the 3.5-inch blank panel and
diskette drive. Remove the screw.
2.
Slide the cage towards the front of the system and lift it out of the unit.
Installing a 3 1/2-Inch Device
Use the following procedure to install a 3 1/2-inch device.
1.
Follow the preinstallation instructions that came with the device, such as setting
jumpers and switches.
Remove the access cover.
2.
Remove and label any cables that interfere with installing the device.
3.
Remove the front panel (see the previous section).
4.
5.
Choose the slot for the device being installed (see Figure 3-16).
Figure 3-15 Removing the Device Cage Screw
Option Installation
3-19
Advertisement
Table of Contents
Troubleshooting
