Table of Contents
Advertisement
Slide the 3 1/2-inch hard disk bracket towards the back of the system unit
until it is free of the molded plastic.
Align the two screw holes on the hard disk with the two tabs on the
bracket. Slide the hard disk onto the tabs.
Figure 3-18 Aligning the Holes and Tabs
Place the hard disk into the bracket and secure with the screw.
Figure 3-19 Securing the Disk
Slide the bracket into the molded plastic drive slot. Secure the bracket to
the front panel with the two screws shown in figure 3-17.
T
If you are installing the device in the 3 1/2-inch internal device slot, simply
insert the drive into the opening until it is secured (see Figure 3-20). Secure
the drive with two screws inserted into the front of the system.
Option Installation
3-21
Advertisement
Table of Contents
Troubleshooting
