NEC DIRECTION L Service Manual page 35

WARNING: An asterisk symbol appearing next
to an option indicates that the selected IRQ is set
to conflict with another device.
NOTE: If you select the Enabled option, you can
see additional options that allow you to specify
the Base I/O address and IRQs for the port you
are configuring.
T
Mode (Serial Port B)
If installed, this option sets the mode for "Serial Port B" to "Normal."
T
Parallel Port
This option configures the system's Parallel Port. Choose "Auto" (default),
"Enabled" or "Disabled." The "Auto" setting causes the Setup program to assign
LPT 1, 378h, IRQ7.
NOTE: If you select the Enabled option, you can
see additional options that allow you to specify
the Base I/O address and IRQs for the port you
are configuring.
T
Mode (Parallel Port)
This option sets the mode for the Parallel Port. The options include "Output
Only" (AT-compatible mode), "Bidirectional" (PS/2-compatible mode), "EPP"
(Extended Parallel Port – high speed bidirectional) and "ECP" (Enhanced
Capabilities Port – high speed bidirectional).
WARNING: An asterisk symbol appearing next
to an option indicates that the selected IRQ is set
to conflict with another device.
To return to the Resource Configuration submenu, press Esc. Then press Esc a
second time to return to the Advanced Menu.
Setup Utility 2-11