How To Start Setup - NEC DIRECTION L Service Manual

2-2 Setup Utility
T
to customize the system with security features such as passwords.
T
to set system parameters after replacing the CMOS battery.

HOW TO START SETUP

To start the Setup utility, follow these steps:
Turn on or reboot the system.
1.
Press F2 after POST begins, but before the system boots up. You have about five
2.
seconds to press F2.
Setup's Main Menu window appears similar to the following screen.
NOTE: The screen shown is typical of a system.
The actual settings on the Main Menu depend
upon the hardware installed in the system.