Power Supply Removal - NEC DIRECTION L Service Manual

5-10 Disassembly and Reassembly

Power Supply Removal

Remove the power supply as follows.
1. Remove the system access cover as previously described.
Label and unplug the power cable attached to the system board.
2.
Label and unplug the power cables from all installed devices.
3.
4. At the back of the system unit, remove the two screws securing the power supply
to the system unit (see Figure 5-10).
Figure 5-10 Removing the Power Supply Screws
Pull the power supply out of the system unit.
5.