Disassembly And Reassembly; Table 5-1 Disassembly Sequence - NEC DIRECTION L Service Manual

Section 5

Disassembly and Reassembly

This section contains step-by-step disassembly procedures for the system unit. Reassembly
is the reverse of disassembly. The procedures are supported by simplified disassembly
illustrations to facilitate removal.
A Phillips-head screwdriver is the only required tool. For complete disassembly of the
system unit, follow the disassembly order listed intable 5-1. To reassemble, follow the table
and procedures in reverse order.
Individual removal procedures do not require the total disassembly of the computer. Each
of the following subsections lists the parts that must be removed before beginning the
removal procedure.
Sequence Part
1 System access cover
2 Expansion board(s)
3 Front panel
4 Side panel
5 Device cage
6 Diskette drive
7 5 1/4-inch device
8 Optional 3 1/2-inch hard disk drive
9 Standard 3 1/2-inch hard disk drive
10 Fan assembly
11 DIMM module
12 Power supply
13 System board

Table 5-1 Disassembly Sequence

See Page
5-2
5-2
5-3
5-4
5-4
5-4
5-5
5-6
5-8
5-8
5-9
5-10
5-11