Replacing The Front Panel - NEC DIRECTION L Service Manual

3-24 Option Installation
11. Secure the device with the screws that came with the device (see Figure 3-22).
12. If you installed a hard drive in the 5 1/4-inch slot, replace the plastic panel.
13. Replace the front panel.
14. Replace the access cover.

Replacing the Front Panel

To replace the front panel, follow this procedure.
1. Align the front panel's six tabs with their corresponding slots on the system (three
of the tabs have holes, the others have prongs).
2. Press the front panel squarely into position until the tabs lock the panel in place.
Replace the access cover.
3.
After securing your system, reboot it and run the Setup program to set the new
4.
configuration.
Figure 3-22 Installing the Device
NOTE: If you removed the accessible device
cage, replace it. Secure the device cage with the
screw.