Accepting A Call; Rejecting A Call; Receiving A Call While In An Application; Using Features/Application During A Call - NEC A232 Manual

Accepting a Call

*
Press (Send) or Softkey 1 (Accept) to connect an incoming call.
To use ring silencer or any key to accept a call, refer to page 37. However, if you already have a call in progress, the any key function does not apply. With a call in
(Send) or Softkey 1 (Accept) to answer an incoming call. (See Flag.)
progress, you must press

Rejecting a Call

*
Press (End/On-Off) or Softkey 2 (Reject) to reject or ignore the call. The call goes automatically to voice mail depending if voice mail is available by your
service provider. (See Flag.)

Receiving a Call While in an Application

If you receive a call while creating a new message, you can accept or reject the call. When you accept the call, the message closes so you may answer the call. The composed
message is saved in the Message center Drafts folder.
If you receive a call while you are in a PIM application (Personal Information Manager, for example entering a phone contact, calendar entry, or a ToDo task), you can
accept or reject the call. When you accept the call, the application closes so that you may answer the call. If you accept a call during text entry or editing changes, the text
entry and changes are not saved.
If you receive a call while you are using the Web browser, you can accept or reject the call. When you accept and end the call, the Web browser screen returns. You are still
connected to the last website accessed.

Using Features/Application During a Call

There are a number of features and tools that you may use during a call. The ones that you cannot use during a call are listed in the following table:
Network Settings
Security Settings
Voice Mail
Browser

Unsuccessful Calls/Auto Redial

With Auto redial set On, your phone will try up to 10 times to redial a number if the first attempt is not successful. If the call cannot be connected, a tone is heard, the
display shows an appropriate message, and the phone returns to Idle. The number is automatically called again after a short delay. The phone will try up to 10 times to
redial the number. The failure to connect a call can be due to network problems or if the other phone is busy.
*
Press Softkey 2 (Cancel) to end a redial attempt.
24
Calls Settings
Camera
Send Messages
Synchronization
Other Settings
Play Voice Memo
If you already have 2 calls in progress
(whether active, on hold, or multi-party), a
third incoming call can not be accepted
because the Softkey 1 (Accept) will not be
displayed on the incoming call screen.
Do not press (End/On-Off) to reject an
incoming call if you already have 2 calls in
progress.
Pressing (End/On-Off) with 2 calls in
progress does not reject an incoming call but
will disconnect a call in progress.
If you attempt to reset the settings during a
phone call, the phone call will disconnect.
Refer to page 47 for more information about
Auto Redial.