Removing A Sim Card; Preparing The Battery; Charging The Battery; Checking The Battery - NEC A232 Manual

Hide thumbs Also See for A232:
Table of Contents

Advertisement

Removing a SIM Card

*
Remove the back cover.
Remove the battery.
Gently press and push the SIM card towards the hinge end of the phone.

Preparing the Battery

Charging the Battery

Your phone is powered by a rechargeable battery. A new phone battery must be fully charged before using your wireless phone the first time. (See Warning.)
Before charging the battery for the first time,
*
Ensure the SIM card is inserted and the battery is in place on the phone. Place the battery terminal end into the battery holder towards the top (away from the
hinged end) of the phone. Lower the battery toward the phone.
Put the back cover plate on the phone. Follow the back cover plate instructions on page 18.
To charge the battery,
*
Connect the NEC battery charger supplied with your phone to a compatible power outlet.
Connect the charger plug into the connector on the base side of the phone. (See picture in right column.)
Check that the recharge battery icon is displayed in the status bar of the main display and the second display backlight glows red (located on the back of the flip).
When charging is complete, the battery icon displays as full and the second display backlight turns off. The battery icon displays on the main LCD display even
when the phone is turned Off during charging.
If you need to receive calls, the wireless phone can be turned On and left in Idle while it is charging, although the total time takes longer to charge.
The wireless phone is designed to be charged with the NEC equipment listed in the specifications of your phone as shown on page 153.

Checking the Battery

The battery charge indicator shows the approximate charge level of the battery while the phone is in use and not being charged. The blocks on the power level icon show the
charge of your battery. The empty battery icon displays when the battery is nearly empty with approximately one minute of talk time remaining. Check the icon at the top,
left corner of the screen (the status bar, see page 7).
Full battery power
DO NOT connect a charger or any other external DC source if the phone's battery is not inserted. If this happens, the phone may not function properly.
Using any battery pack or AC adapter not specified by NEC for use with this phone creates a potential safety hazard that may be dangerous and may void any
approval given to the wireless phone.
Do not connect more than one charger at any time.
Do not leave the charger connected to the power supply when it is not in use.
Low battery power
Battery empty (red)
Do not try to charge the battery if the
temperature is below 5 °C (41 °F) or above 35
°C (95 °F).
19

Advertisement

Table of Contents
loading

Table of Contents