Performance; Third Party Equipment; Service; Efficient Use - NEC A232 Manual

Performance

Third Party Equipment

Use only batteries, chargers, and authentic accessories approved by NEC. Modifications, the use of third party equipment, cables, or accessories that are not made or
AUTHORIZED by NEC may invalidate any approval of your phone, may adversely affect the phone's operation, and may be dangerous. For availability of approved
accessories, check with your wireless phone dealer.

Service

The wireless phone, batteries and charger do not contain user-serviceable parts. We recommend that your NEC wireless phone be serviced or repaired by an NEC
AUTHORIZED service center.

Efficient Use

For optimum performance with minimum power consumption, hold your NEC a232 wireless phone (with the flip open) as you would any other phone and speak directly
into the mouthpiece.

Battery

The NEC a232 phone contains an 700 mAh, standard Lithium-ion battery. Battery performance depends upon signal strength, network configuration, phone features
selected, battery age and condition, battery charging habits, temperatures to which battery is exposed, and many similar factors. (See flag.)

Antenna

Your phone has an internal antenna located at the base of the phone below the keypad. As with any other
radio transmitting device, avoid touching the antenna area when the phone is turned On to optimize the
antenna performance and talk time of the phone. Contact with the antenna area may affect call quality and
may cause the phone to operate at a higher power level than otherwise needed.
Look for the NEC Authentic Accessories TM logo to know if the item has been approved by NEC for use with the NEC a232.
Not using NEC Authentic Accessories TM or not
using NEC approved accessories may damage
your phone.
Your a232 battery maintains an
"over-discharge protection" that turns the
battery off when the voltage falls below 2.4V.
If this voltage drop occurs, the battery will
require a longer charge period (the duration
depends upon the extent of "over-discharge",
though typically 5 to 15 minutes longer than
the standard charge time). During this
particular charge period, the Charging LED
will not illuminate.
The mouthpiece is located in the same area as
the antenna.
15