The unit can support up to 253 local clients. Addresses are assigned to
DHCP S
ERVER
clients from a common address pool configured on the unit. Configure an
address pool by specifying start and end IP addresses. Be sure not to
include the unit's IP address in the address pool range.
Figure 38: DHCP Server
The following items are displayed on this page:
LAN IP Address — Displays the LAN IP address for management of
◆
the ADSL Router. (Default: 192.168.2.1.)
◆
Subnet Mask — Displays the local subnet mask.
(Default: 255.255.255.0)
DHCP Mode — When set to "DHCP Server," enables the ADSL Router to
◆
act as a DHCP server.
Interface — Selects either the RJ-45 LAN ports, or wireless interfaces.
◆
◆
IP Pool Range — Configures the IP address pool for the DHCP server
and determines how many IP addresses can be assigned.
N
:
OTE
range.
Show Client — Displays the current DHCP client table.
◆
Default Gateway — Specifies the gateway address through which
◆
traffic is routed from. Usually the LAN IP address of the ADSL Router
Do not enter the ADSL Router's LAN IP address as part of the IP Pool
– 78 –
| LAN Settings
C
6
HAPTER
DHCP Settings