Wds; Figure 30: Wds Configuration - SMC Networks SMC7904WBRAS-N2 V2 User Manual

WDS

Broadcast SSID — Enables/disables the wireless interface to
◆
broadcast an SSID (service set identifier) to uniquely identify it on the
network.
◆ Relay Blocking — Blocks traffic between SSID interfaces.
Authentication Type — Sets the basic authentication method for the
◆
VAP interface.
Each access point radio interface can be configured to operate as a bridge,
which allows it to forward traffic directly to other access point units. To set
up bridge links between access point units, you must configure the wireless
Distribution System (WDS) forwarding table by specifying the wireless MAC
address of all units to which you want to forward traffic. Up to six WDS
bridge links can be specified for each unit in the wireless bridge network.

Figure 30: WDS Configuration

To set up WDS all connected routers should be in the same subnet, with
DHCP disabled on all routers not connected to the WAN and the MAC
address of each router set first.
Follow the steps detailed below:
The wireless setup must be the same on all connected routers.
1.
– 68 –
| WLAN Configuration
C 5
HAPTER
WDS