Rip Configuration; Figure 64: Rip Configuration - SMC Networks SMC7904WBRAS-N2 V2 User Manual

RIP C
ONFIGURATION
RIP is an Internet protocol you can set up to share routing table
information with other routing devices on your LAN, at your ISP's location,
or on remote networks connected to your network via the ADSL line. Most
small home or office networks do not need to use RIP; they have only one
router, such as the router, and one path to an ISP. In these cases, there is
no need to share routes, because all Internet data from the network is sent
to the same ISP gateway.

Figure 64: RIP Configuration

The following items are displayed on this pages:
RIP — Enables or disables RIP on the unit. (Default: Disabled)
◆
◆ Interface — The name of the interface on which you want to enable
RIP. (Default: br0)
Receive Version — Indicate the RIP version in which information must
◆
be passed to the DSL device in order for it to be accepted into its
routing table.
Send Version — Indicate the RIP version this interface will use when it
◆
sends its route information to other devices.
– 113 –
| Services
C 8
HAPTER

RIP Configuration