Smart Board 6055 And 6065 Command Inventory; Power State - Smarttech SMART Board 6000 Series Administrator's Manual

APPENDIX B
REMOTELY MANAGING THE INTERACTIVE FLAT PANEL
NOTE
You must connect the video input to the interactive flat panel to set a value for it, but the
video input doesn't need to be in use.
To increase or decrease the value of a setting
Use the set command to increase or decrease the value by a designated number.
This example increases the contrast level by 5:
>set contrast +5
contrast=70
This example decreases the contrast level by 15:
>set contrast -15
contrast=55
SMART Board 6055 and 6065
command inventory
This section contains the commands for SMART Board 6055 and 6065 interactive flat panels.

Power state

Use the following commands to identify power state settings.
Command
get intpowerstate
get powerstate
59 smarttech.com/kb/170642
Response
intpowerstate=[Value]
powerstate=[Value]
Possible values
on
standby
dpms
novideo
confirm
proximitywait
welcome
on
off
standby
Standby
mode
Yes
Yes