Seakeeper ConnectBox User Manual page 25

SEAKEEPER CONNECTBOX USER'S MANUAL
PRODUCT CONNECTBOX
CONNECTBOX SOFTWARE AND UPDATING
The software for the ConnectBox user interface is periodically updated. Owners and dealer
technicians can access the most up-to-date software version from the
Library Software folder. There is a bulletin in the folder describing how to update the display and
ConnectBox software. Dealers may also obtain the up-to-date ConnectBox software from the
Seakeeper Service Tool application.
A thumb drive, an OTG cable, and a Torx-8-bit driver is required to update the ConnectBox
software. Seakeeper sells a kit
required tools. This kit is necessary even if using the Seakeeper Service Tool application to obtain
the software.
The side panel shown in Figure 33 provides access to the ConnectBox micro-USB connector (to
which the OTG cable connects).
Figure 33: ConnectBox side panel micro-
USB plug and two Torx-8 screws
The currently loaded ConnectBox software version
can be viewed from the application's Information
DISPLAY
screen beside
If an optional 5" display is used, the ConnectBox
software version will be displayed on the
Information screen on the 5" display, as shown in
Figure 35.
Page 25 of 27
Document # 90769-1
(P/N 20479) on the Partner Center website that contains the
. See Figure 34.
Seakeeper Technical
Figure 34: Information screen
Figure 35: Information screen of 5" display with
ConnectBox
www.seakeeper.com