Icom IC-706 Instruction Manual page 41

. |. 4 Select *
© Select VFO mode.
Q Select the desired operating mode.
*The operating mode can also be changed while scan-
ning.
© Set [SQL] open or closed.
«See je a left for squelch condition.
,, then push [(F-1)3 CH] to start the scan.
"Decimal point blinks while Adis
(€ To cancel the scan push [(F-1):: CH].
E Memory scan operation
© Select memory mode.
Q Close the squelch with [SQL].
© Select 5Z, then push [(F-1)::12H] to start the scan.
* Decimal point blinks while scanning.
@ When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
© To cancel the scan push [(F-1)5F].
E Select memory scan operation
© Select memory mode.
Q Close n Dia with [SQL].
@ Select 5, then push [(F-1)51:H] to start the mem-
ory scan.
* Decimal point blinks while scanning.
@® Push [(F-2):i:1.] to change the memory scan to
select memory scan.
© When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
© To cancel the scan push [(F-1) 52H].
B Priority watch
(D Select VFO mode, then set a frequency. |
@ Close the squelch with [SQL].
© Set the desired memory channel as the watching
channel.
€ Select 5, then push [(F-2)" E T] to start the watch.
* Decimal point blinks while scanning.
& When the scan detects a signal, the scan pauses
for 10 sec. or until the signal disappears, depend-
ing on the resume setting.
© To cancel the scan push [(F-2) ^ & I].
pet P i ? x I» Select
Lc c ILLU VFO mode
$1357
9 20 40 60d8
VFOA
>
M r "HN Select watching
S2 SCM PRI Lej channel
SN
USB
iH co^ ET
Ee DET Select
$135 7 9 2 40 $68 VFOA -«————— ——-
VFO mode
62 SCh PŘI
then push [(F-1)5 1H]
Select
P mem mo
(cH Py de
then push [(F-1) 5TH]
NOTE: 2 or more memory channels must be pro-
, grammed for memory scan to start.
Select
memory mode
1*- Designate
"S."
Push [(F-1)S CH], then [(F-2)SEL ].
NOTE: 2 or more memory channels must be des-
ignated as select memory channels for select
memory scan to start.
USB
Push [(F-2)F F I].
OTE: The paused condition when detecting a
signal differs depending on the scan resume con-
dition.
resume on: pauses for 10 sec.
resume off: pauses until the signal disappears.
s
38