Icom IC-706 Instruction Manual page 39

E Memo pads
The default number of memo pads is 5, however, this
can be increased to 10 in initial set mode if desired
(p. 44).
* Writing frequencies and operating modes
into memo pads
© Select the 1 display.
e Push [DISP] 1 or 2 times to select 5.
e Push [MENU] one or more times to select 5:1.
ZG NOTE: Each memo pad must have its own unique
7 combination of frequency and operating mode;
Z, memo pads having identical settings cannot be
ZZ written.
My
N
*Calling up a frequency from a memo pad
You can simply call up the desired frequency and
operating mode of a memo pad by pushing
[(F-3) Ff] in the 5:1 display.
*Make sure 31 is selected in advance.
* Both VFO and memory modes can be use.
*The frequency and operating mode are called up, starting
from the most recently written.
When you call up a frequency and an operating
mode from memo pads with [(F-3)4F E], the previ-
ously displayed frequency and operating mode are
automatically stored in a temporary pad. The fre-
quency and operating mode in the temporary pad
can be recalled by pushing [(F-3)lF'F] one or more
times.
* You may think there are 6 memo pads because 6 different
frequencies (5 are in memo pads and 1 is in the tempo-
rary pad) are called up by [(F-3)MF'F].
NOTE: If you change the frequency or operating
mode called up from a memo pad, the frequency
and operating mode in the temporary pad are
erased.
SN
=
Displayed frequency and mode
Push PELI
2 waz? Y s
Newest
Oldest
The oldest written frequency
and mode are erased.
MEMO PADS
VFO or MEMORY
mode display
Pushing [(F-3)MF F] calls
up the frequency and
operating mode ina
memo pad and the
temporary pad
sequentially.
Frequency and mode before
pushing [(F-3) FF).