Icom IC-706 Instruction Manual page 40

37
5 MEMORY AND SCAN OPERATION
ll Scan types
PROGRAMMED SCAN
Repeatedly scans between two scan edge frequencies
(scan edge memory channels P1 and P2).
Scan edge P1 or P2 Scan edge P2 or P1
This scan operates in VFO mode.
MEMORY SCAN
Repeatedly scans all programmed memory channels.
S (select)
S (select)
(Men 3) S (select)
S (select)
S (select)
This scan operates in memory mode.
B Preparation
* Channels
For programmed scan:Program scan edge frequen-
cies into scan edge memory channels P1 and P2
(p. 33).
For memory scan:Program 2 or more memory chan-
nels except scan edge memory channels.
For memory select scan: Designate 2 or more memo-
ry channels as select memory channels—select a
memory channel, then push [(F-2 =EL] in the =i dis-
play (memory mode) to designate the channel as a
select memory channel.
For priority watch: Program 1 memory channel to be
. watched.
«Scan resume ON/OFF
You can select the scan to resume or cancel when
detecting a signal, in initial set mode, item 9. Scan
resume ON/OFF must be set before operating a scan.
See p. 43 for ON/OFF setting and scan resume con-
dition details.
PRIORITY WATCH
Memory channel watch
Call channel watch
Call
channel
VFO Memory . VFO
frequency channel frequency
This scan operates in VFO mode.
SELECTED MEMORY SCAN
Repeatedly scans all selected memory channels.
S (select)
S (select)
This scan operates in memory mode.
S (select)
S (select) S (select)
Scan speed
Scan speed can be selected from 2 levels, high or low,
in initial set mode. See p. 43 for details.
¢Squelch condition
The scan continues | Scan pauses on each
until it is stopped | channel when the scan
manually, and does | resume is ON; not ap-
not pause even if it | plicable when OFF.
detects signals.
This is not applicable
when the scan re-
sume is OFF and a
programmable step
(more than 1 kHz) is
selected.
Scan stops when detecting a signal.
4| lf you set scan resume ON in initial set mode,
| the scan pauses for 10 sec. when detecting a
signal, the resumes. When a signal disappears
while scan is paused, scan resumes 2 sec. later.