Headset Docking-Operation; Re-Running The Setup Wizards - Jabra GO 6470 User Manual

8.8

headSet docking-oPeRation

whenever the headset is docked correctly in the base's cradle, the successful electrical connection to the base is
indicated by an icon in the touchscreen's status bar as shown below:
Figure 41: The touchscreen indicates that the headset is docked successfully
docking operations (lifting and replacing the headset to/from the recharge cradle) simulate the pick-up and
hang-up operations of a traditional phone as follows:
- whenever you dock the headset to the base, all current calls will be terminated.
- If the base is able to detect that a connected phone is ringing, then lifting the headset will answer that
line and open an audio connection to the ringing phone. however, not all types of phone support ring
detection.
8.9

Re-Running the SetuP wizaRdS

the very first time you turn on the Jabra GO base, a setup wizard launches automatically, helping you to
configure the connection to your desk phone, mobile phone and/or computer. thereafter, the base starts
normally each time your turn it on. however, if you would like to revisit your desk-phone, computer and/or
mobile-phone setup, you can do so at any time. In each case, an on-screen wizard will help you make the relevant
settings.
Figure 42: Finding the setup wizards
SETTINGS
Disable Audio
detection
Advanced
About
Jabra GO 6470 User manUal
ADVANCED SETTINGS
Setup Wizard
Reset
Configuration
Desk Phone
51