Configuring The Jabra Go Base For Your Desk Phone - Jabra GO 6470 User Manual

4.5

configuRing the JabRa go baSe foR youR deSk Phone

when the touchscreen wizard is helping you set up your desk phone, it will ask you to call a Jabra test server. this
enables the Jabra GO base to test its clear dial-tone-switch and microphone-level settings by exchanging signals
with the test server.
Important: your headset will not work correctly with your desk phone until you have set both the
termination switch and microphone level as described in this section. you must repeat these procedures
if you move the headset to a new type of desk phone.
Setting the Clear Dial-tone Switch to find a Clear Dial-tone
follow the procedure below to find the best position for the clear dial-tone switch on the Jabra GO base; the
correct position varies by desk phone model.
Figure 11: Setting the clear dial-tone switch manually
there is no clear dial-tone switch accessible to the user on the base — stepping through positions a – G to
find the best one occurs automatically. you simply need to call the Jabra test server and follow the on-screen
instructions.
If the Jabra GO 6470 base cannot contact the Jabra test server:
In this case, you can choose to set the switch manually:
1. put on the headset.
2. Tap the multifunction button at the back of the headset to activate the audio link to your desk phone.
3. press the headset button on your desk phone (or lift the handset from your desk phone and set it aside). this
connects your desk phone to the phone network.
4. when prompted to do so by the wizard, step slowly through each position (a – G) of the clear dial-tone switch
on the touchscreen (desk phone setup wizard, manual setup), listening for a dial tone in your headset at each
one. find the setting where the dial tone is strong, clear and undistorted.
If positions a and G both sound best, then choose position a; if another pair of positions sound best, then
pick one and remember the other one — you will find which of these settings is best when you are testing the
microphone level (see below).
5. press the headset button on your desk phone (or hang up the handset) to disconnect from the phone
network. then tap the multifunction button at the back of the headset to de-activate the audio link to your
desk phone.
6. set the microphone level, as described in the section below.
Jabra GO 6470 User manUal
19